Sicherheit und Leistung LiPo-Akkus | Swaytronic

High quality 3in1 battery balancer / discharger / cell monitor This balancer can be used for Lipo and LiFe batteries. It measures the cell condition and can be used as a balancer to optimally balance the cells. In discharge mode, the cells can also be prepared for winter storage, for example.The cell charge status is displayed during the entire balancing process. This means that faulty cells can also be detected quickly before a crash is risked in flight.Supported battery types: Li-Polymer / Li-Fe:2 - 6 cells / 7.4V -22.2V Balance Setting Range (lower limit) : 2V - 4.2V (preset with 3.3V) Discharge Setting Range (lower limit) : 2V - 4.2V (preset with 3.9V)

LiPo voltage tester 1S - 8S digital and programmable This voltage tester shows you the condition of your battery or cells within seconds. 1-8S Lipo / Li-ion / LiMn / Li-Fe.Voltage detection Accuracy: ± 0.01 V1S test mode Voltage range: 4-15VLow voltage alarm mode for 2-8SAlarm set point range: Off 2.7-3.8VWeight: 9g Functions:  Display total voltage (all cells) and the individual voltage of each cell.During operation / use of a LiPo battery, the battery tester monitors the battery. The individual cells are permanently checked for their voltage and the alarm is automatically triggered when the set cell voltage of the cells is reached / undercut.Connect a battery (1-8 cells LiPo) to the balance plug of the battery tester. The voltage tester acknowledges the connection of the battery with 2 x 5 beeps. The display shows the total voltage (ALL) of the battery in volts and then changes to the voltage of the individual cells (No 1...No 2... No 3... etc.)  Setting the alarm for the cell voltage you want: Press the button (lower edge button) once. The tester shows the currently set voltage value in volts (based on 1 cell). If this value corresponds to your wish, the programming is finished and the battery tester changes back to the home position in the display.If you want to change the alarm value, press the button twice. The battery tester switches to the next possible value.Repeat this step until the setting you want is displayed. Programme options: OFF / 2.70 V to 3.8 V at intervals of 0.10VPress the button once  =display the set alarm valuePress the button twice=switch to the next valuePress the button several times to scroll through all values.  Recommendation:The alarm value should not be set below 3.3 volts! LiPo batteries react very sensitively to deep discharge. 

Swaytronic Charge Marker (2pcs.) Charge Marker - manual charge level indicator red/greenWho doesn't know the problem of losing track of the charge level with many batteries? The solution now comes in the form of the small and ingenious Charge Marker. The Charge Marker can be the Charge Marker can be attached directly to the battery using an integrated adhesive strip and can be used immediately. Slide the slider to green after charging. After use, simply switch the slider back to red. This way you'll never lose control of the charge level of your batteries again and you'll always be ready for another flight!